DIY : How to?

Proces of changing housings consist from 3 steps

1

PREPARATION

prepare good working space

2

DISASSEMBLY

remove all parts from original housing

3

ASSEMBLEY

installing all parts into new HONU housing

 
 
 

ASSEMBLY

STEP 1:

  1. you need to remove and put into place, lenses for camera and flash
  2. you also need remove and put into place a display holding pins

STEP 2:

place Wi-FI and bluetooth antena, back into place

STEP 3:

install dock connector into place

NOTE: when dock connector is in place, plug in charging connector, so it will stay into place.

STEP 4:

put soundspeaker on top of the dock connector and secure it with tightening the first screw

STEP 5:

tighten all other screws in dock connector so everything will stay firmly in place

STEP 6:

put “audio control and power button cable” into place

STEP 7:

tighten the volume and power buttons with screws

NOTE: screws are marked with red dots

STEP 8:

connect thin round cable to backside of logicboard

NOTE: easyiest way is shown in movie at 10:30

STEP 9:

place logicboard with camera and flash into place and tighten all screws

NOTE: you need to lift above logicboard flat cable connector from “volume power cable”

STEP 10:

tighten the camera and flash with the support bracket and with two screws

STEP 11:

install vibrator over Wi-Fi and bluetooth antena and tighten 3 screws

STEP 12:

install new battery that comes with the package, and glue it to housing

NOTE: do not connect battery to logicboard

STEP 13:

install display, by pressing connectors from display to logicboard

NOTE: this may give you some problems, take your time, and dont be nervous

STEP 14:

screw LCD shield plate into place with 3 screws

STEP 15:

  1. connect battery to logicboard
  2. screw two battery shield plates into place with 3 screws

STEP 16:

  1. fold display into housing
  2. screw display with two bolts at the bottom
 
 
 

Join us:

subscribe for news:

 
 
 

Follow us